Volvo VNM Manuel de l'opérateur Page 91

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 389
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 90
84 Additional Safety Features
Important Facts About Safety Belts in Heavy Trucks
The high mileage associated with heavy
trucks, the continual relative movement of
the seat with the cab, the possible contact
with the vehicle seat or other parts of the
cab structure, and the potential exposure
of this safety belt to severe environmental
conditions make it crucial to inspect the seat
belt system regularly. It is recommended
that the system is inspected every 15,000
miles (24,000 km) or more often if the
vehicle is exposed to severe environmental
or vocational conditions. Any safety belt
system that shows cuts, fraying, extreme
or unusual wear, significant discolorations
due to ultra-violet ray exposure, dusty-dirty
conditions, abrasion to the safety belt
webbing or damage to the buckle, latch plate,
retractor, hardware or any other obvious
problem should be replaced immediately,
regardless of the mileage.
Once replacement of the safety belt has
been determined necessary, be certain that
it is replaced only with a Volvo original
replacement safety belt. See your authorized
Volvo Truck dealer for replacement. Your
Volvo safety belt system has been developed
and tested specifically for heavy trucks.
Replace it only with the exact same design
that the vehicle was equipped with.
If the inspection indicates that any other
part of the safety belt system requires
replacement, the entire belt system must be
replaced. An installation guide is attached
to every replacement system, entitled
“Three-Point Safety Belt Installation Guide.
There are separate safety belt instruction
guides for suspension and stationary seats.
Use the proper guide for your type of seat
and follow the instructions very closely. It
is vitally important that all components are
mounted back in the same positions as the
original components that were removed.
This will maintain the design integrity of the
mounting points for the safety belt assembly.
Vue de la page 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 388 389

Commentaires sur ces manuels

Pas de commentaire