Volvo 2010 V50 Manuel du propriétaire télécharger pdf (Page 140)

06 Starting and driving

Starting the engine – Flexifuel

06

``

* Option/accessory, for more information, see Introduction.

139

General information about starting

with Flexifuel

The engine is started in the same way as in a

petrol-engined car, see page 137.

NOTE

The immobiliser is activated in the event of

repeated start attempts. Before a new start

attempt is made the key/dial must first be

turned back to position I or 0.

In the event of starting difficulties

If the engine does not start at the first start

attempt, proceed as follows:

1. Depress the accelerator pedal 1/3 to 1/2.

2. Turn the remote control key/ignition dial to

key position III.

3. When the engine has started, ease the

accelerator pedal gradually as the engine

speed increases.

If the engine has not started after

10 seconds, second attempt

±

Turn the remote control key/ignition dial to

key position III until the engine starts, but

not longer than 60 seconds.

If the engine still does not start

±

Please wait for one minute, fully depress

the accelerator pedal and repeat the pre-

vious procedure.

IMPORTANT

If the engine does not start despite repeated

start attempts, contact a workshop - an

authorised Volvo workshop is recom-

mended.

Engine block heater*

Electrical input to the engine block heater.

When the temperature is expected to be lower

than –10 °C and the car has been refuelled with

bioethanol E85, an engine block heater should

be used for about 2 hours to facilitate the quick

starting of the engine.

The lower the temperature, the longer the time

required with the engine block heater. At

-20 °C the heater should be used for approx. 3

hours.

Cars intended for E85 have an electric engine

block heater*. Starting and driving with a pre-

heated engine involves significantly lower

emissions and reduced fuel consumption. For

this reason you should aim to use the engine

block heater throughout the winter months.

WARNING

The engine block heater is powered by high

voltage. Fault tracing and repair of an elec-

tric engine block heater and its electrical

connections must only be carried out by a

workshop - an authorised Volvo workshop

is recommended.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 297 298

Commentaires sur ces manuels

Pas de commentaire