Volvo PENTA Manuel de service télécharger pdf (Page 140)

137

Repair instructions

Adjusting the retaining pawl,

model 290

a) Set the control lever in the ‘Forward’ position and

check that the lever (8) does not touch the hous-

ing. See position “C” on the picture.

Check with the control lever in ‘Forward’,

‘Reverse’ and in ‘Neutral’ that the swivel (9) and

the cable attachment (7) does not strain in the

shift plate (8).

Adjust by easing off the locking nut and then by

altering the position of the swivel (9) on the shift

cable. Tighten the nut after the adjustment.

b) Set the control lever in ‘Neutral’ and check that

the rod (6) has a position that it will touch the

yoke of the retaining pawl at “A”. However, with-

out pressing against it.

Adjust if necessary the yoke (11). If a second

adjustment is made, also point a) has to be ad-

justed once again.

Oil filling

2. Tilt the sterndrive to the full up position. Remove

the fill plug (1) and fill with approx. 2.2 liters of GL-5

synthetic gear oil. See

Techical Data

. Install the fill

plug with a new gasket.

Tighten the fill plug to 35 Nm (26 lb.ft.).

Lower the sterndrive and check the oil level with the

dipstick. If necessary, Top off the sterdrive with oil

through the dip stick hole.

3. Install the shift mechanism cover.

1. Install the oil drain plug with a new O-ring (1).

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 180 181

Pas de commentaire

Volvo PENTA Manuel de service Page 140