Volvo RTI Guide d'installation Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 19
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
Page 9
Reversing Camera Connector
If you do not wish to use our ‘X1’ reversing camera then you can purchase just the connector that goes
into the port labeled ‘Camera’ of the iMIV Classic. Utilization of a different style reversing camera with
LE series devices is not easily possible.
The Reversing Camera Connector is supplied with five crimp contacts, one as a spare. Looking at the
connector in the iMIV Classic and starting from left to right, the pin out is as follows:
Ground
Switched Power In
Video Ground
Video Signal
Switched power should only be enabled when the reverse lights are on, as this overrides any video feed
that the iMIV Classic might be displaying.
Please Note: The factory Volvo RTI screen uses a PAL signal only, NTSC cameras will not function
properly. Sensolutions Inc. cannot provide technical support for installing an unsupported camera or
offer warranty for iMIV Classic devices that are damaged due to incorrect wiring.
Universal Video Output Cable
If you purchased an iMIV Classic but have an aftermarket LCD screen it is possible to connect the video
feed from the iMIV Classic to it using the Universal Video Out Cable. The cable comes with pre-crimped
connecters that simply need to be inserted into the existing blue power connector of the iMIV Classic.
With the tab of the connector and the side where the wire exits facing toward you the pin out is as
follows, starting right to left.
1) 12v Positive In
2) 12v Negative In
3) Switched Positive Out
4) Video Ground
5) Video Out
Bend up the safety latch of the blue connector and insert the black wire into location four and the white
wire into location five. Push the retaining latch back down and reinsert the connector back into the iMIV
Classic.
Please Note: Sensolutions Inc. cannot provide technical support for installing generic video screens or
this cable, or provide warranty for iMIV devices or wiring that is damaged due an incorrect installation.
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Commentaires sur ces manuels

Pas de commentaire