Point - applies to the S80
● Remove the rubber grommet on the cable for the passenger compartment
connector socket.
● Cut the top off the large rubber cap on the recently routed rubber grommet for
the cable harness
● Apply low temperature grease (P/N 1161417-
9) to the rubber grommet to
facilitate routing the cable to the passenger compartment connector socket
● Insert the cable for the passenger compartment connector socket. Insert the
cable through the rubber grommet.
● Insert the cable for the passenger compartment connector socket and the single
cable into the passenger compartment.
Point - applies to the S80
● Route both cables to the front edge of the sill on the right-hand front door
●
Continue to route the single cable along the right
-hand side of the car inside the
floor carpets and insulation. Route the single cable to the accessory electronic
module (AEM) located on the right
-hand side in the cargo compartment rear
wheel well. Ensure that the single cable is positioned so that there is no risk of it
catching or rubbing
● Secure at the cable duct in the cargo compartment. Use the three tie straps (1)
from the kit.
Point - applies to the S80
● Lift the accessory electronic module (AEM) out of the bracket.
Installation instructions, accessories
-
Relay EPH
Volvo Car Corporation G
öteborg, Sweden
Installation instructions, accessories
-
Relay EPH
Volvo Car Corporation G
öteborg, Sweden
©
VolvoCar Corporation, 2003 Printed in Sweden
©
VolvoCar Corporation, 2003 Printed in Sweden
Page 10 of 22
Commentaires sur ces manuels